This model can be manufactured on request in the standard sizes.
For performance data and dimensions, see E-Type and B-Type.
Fig. 1
With bearing-supported flange
A flange supported on a hollow shaft and bearings is used for the output side connection. Holes in the flange can be used to attach pulleys, sprockets etc.
Fig. 2
With a flexible coupling
If an axial or angular misalignment is to be expected between two shafts, a flexible coupling can be attached.
Fig. 3
With bearing-supported belt pulley
The output drive is a single-groove belt pulley (see Fig. 4) which is supported on a hollow shaft.
The pitch diameter can be supplied to the customer‘s requirements. Multiple-groove pulleys can also be supplied.
Common groove forms are: SPA, SPB, SPZ, and Poly-V to DIN/EN.
Fig. 4
With belt pulley supported on separate bearings
Here the output drive is a single or multiple-groove belt pulley which is separately supported, not on the hollow shaft of the electromagnetic clutch.
The pitch diameter of the pulley can be supplied to the customer’s requirements.
Common groove forms are: SPA, SPB, SPZ, and Poly-V to DIN/EN.
Fig. 5
With sprockets
A chain sprocket mounted on a bearingsupported flange transmits torque on the output side.
Fig. 6
Contact persons:
Sales Germany
Mr. Klaus Franzen
Tel.: +49-7142-597-11
Fax.: +49-7142-980151 contact form
International sales
Mr. Joachim Lutz
Tel.: +49-7142-597-10
Fax.: +49-7142-980151 contact form
Engineering
Mr. Ulrich Kowatsch
Tel.: +49-7142-597-57
Fax.: +49-7142-980151 contact form
